Anthem AVM 20 v2 - Manual (Page 43)

36
6. REMOTE CONTROL OPERATION
continued …
6.2 PATH SELECTION
• MAIN: Press MAIN in Path/Component, then press .
• ZONE2 or ZONE3: Press Z2 (or Z3) in Path/Component, then press .
• RECORD: Press MAIN in Path/Component, press , then press REC in SSP Path.
6.2.1 COPYING THE MAIN PATH TO ZONE2, ZONE3, OR RECORD
Select a MAIN Source first and then for:
• ZONE2 or ZONE3: Press Z2 (or Z3) in Path/Component, then press COPY.
• RECORD: Press MAIN in Path/Component, press REC in SSP Path, then press COPY.
Note: The REC key only works when Path/Component is in MAIN.
Note: While all Analog Sources are simultaneously available to MAIN, ZONE2, ZONE3, and RECORD, the
COPY function is the only way to direct a MAIN Digital Source to ZONE2, ZONE3, or RECORD.
6.3 SOURCE SELECTION
After selecting the desired Path (MAIN, ZONE2, ZONE3, or RECORD), press one of ten SOURCE keys in the
SSP Source group near the bottom.
6.3.1 SOURCE SEEK (Remote Control Only)
The SOURCE SEEK keys are an easy way to find the active Sources. The keys go to the previous and
next active Source while the key advances one Source at a time.
6.4 DIRECT FM • AM STATION ENTRY (Remote Control Only)
When using the FM • AM Tuner, the station frequency can be entered as a four-digit number. For example, to
tune into 98.3 FM, press and hold SELECT until the display shows “<blank>0.0” in the lower left corner, then
press 0, 9, 8, 3.
6.5 SLEEP TIMER (Remote Control Only)
If you would like to go sleep while listening to a program or music, the Sleep Timer will automatically turn
the AVM 20 power off after a preselected time. So when you find yourself falling asleep at the ‘tube’, take the
Remote Control and:
• Select the desired Path (MAIN, ZONE2, or ZONE3), then press SLEEP (the Sleep timer will operate
for that Path only).
• The first SLEEP keystroke always resets the timer to 30 minutes. Additional keystrokes then cycle
as follows: Second=60, third=90, fourth=Disabled.
• Once set, the time remaining appears as the number following ‘Zzz’ in the display.
6.6 ENABLE / DISABLE TIMERS (Remote Control Only)
To enable or disable all timers without entering the Setup, press and hold the SLEEP key until the display
shows “All Timers”, then use the
keys to enable/disable (see section 7.4.1).