Anthem AVM 20 v2 - Manual (Page 61)

Program Preset Selections
• 2-Ch For stereo source material, select from any Mode described in section 5.8.3, or Last Used.
In addition, Dolby Pro Logic, Pro Logic II-Movie, and Neo:6 Cinema can be preset either
with or without THX Cinema.
The following presets apply to Digital inputs only:
• DD-2.0 For two-channel Dolby Digital material, you can use the same selection as for stereo
source material, Pro Logic II-Movie: Auto (see section 5.8.2) with or without THX Cinema,
or Last Used.
• DD-5.1 Presets a THX mode for Dolby Digital 5.1 material: THX Cinema, THX Ultra2 Cinema, THX
MusicMode, THX Surround EX, Off, or Last Used (see section 5.8.6).
• DTS-5.1 Presets a THX mode for DTS-5.1 material. THX Cinema, THX Ultra2 Cinema, THX
MusicMode, Neo:6+THX, Off, or Last Used (see section 5.8.6).
• DD-EX For material encoded in Dolby Digital Surround EX. Select Dolby Digital EX: On, Auto, Off,
or Last Used. It is also possible to set On or Auto together with THX Surround EX – this
allows automatic engagement of THX Surround EX for flagged Surround EX material while
engaging a different THX mode for non-flagged material (see section 5.8.4).
• DTS-ES For DTS-ES material. Select Neo: 6 On or Auto, with or without THX, or Last Used (see
section 5.8.5).
54
7. SETUP MENU
continued …
Audio Group Delay:
Using line doublers, quadruplers, or scalers causes the video to be delayed, which means that you will hear
sound slightly ahead of seeing the video picture. This can also occur with HDTV and satellite broadcasts. To
compensate for this video delay, Audio Group Delay can delay sound of all channels simultaneously by up to
85 milliseconds – please check the owner’s manual for your doubler, quadrupler, or scaler for recommended
delay settings. If you do not know the recommended delay settings, you can adjust Audio Group Delay
outside of the Setup Menu – this allows you to see the picture as you make adjustments (see section 6.7).
Mode Presets:
You can pre-select the Mode and THX preference that will be applied when a Source is selected, or MAIN
power is turned on. There are separate settings for each type of program material.
To disable a preset, set it to ‘Last Used’. Presets are not available for Sources set to Anlg-Dir.
For complete descriptions of surround modes and when to use them, refer to section 5.8.
Use the buttons to highlight one of the lines above in the menu, then use the buttons to scroll
through the selections.
Certain combinations are not possible, for example, Dolby Digital EX can only take effect if THX is off. Should
a conflict arise, the rules by which the AVM 20 overrides settings are as follows:
When THX is set to Cinema, Ultra2 Cinema, MusicMode, or Surround EX and...
• Dolby Digital EX is set to Off, then the selected THX mode takes effect.
• Dolby Digital EX is set to On, then THX Surround EX is automatically engaged.
• Dolby Digital EX is set to Auto and the source material has no Dolby Digital Surround EX flag, then
the selected THX mode takes effect.
• Dolby Digital EX is set to Auto and the source material is flagged, then THX Surround EX is
automatically engaged.