Anthem AVM 20 v2 - Manual (Page 44)

37
6. REMOTE CONTROL OPERATION
continued …
6.7 AUDIO GROUP DELAY (Remote Control Only)
To adjust Audio Group Delay without entering the Setup, press and hold the DISPLAY key until the display
shows “Audio Group Delay”, then use the
keys to move from digit to digit and the keys to adjust.
This can be done while viewing the picture and listening to the soundtrack simultaneously (see section 7.4.5).
6.8 CONTROLLING OTHER COMPONENTS
The AVM 20 Remote Control can be set up to control your TV, DVD player, CD player, VCR, and satellite
receiver. It contains a very extensive set of Remote Control codes from many different manufacturers, which
can be entered to virtually duplicate another Remote Control. Alternatively, the Learn function can be used
to customize each key.
6.8.1 ENTERING MANUFACTURER’S CODES
In Appendix A at the back of this manual you will find the manufacturer’s codes available for programming
the AVM 20 remote. To enter a code:
1. Press the Path/Component key (e.g. DVD).
2. Press and hold LEARN until the LED flashes twice.
3. Enter the four-digit code from Appendix A. The LED should blink twice.
Codes can only be used with their respective Path/Component key. For example, a VCR code can not be
programmed in the DVD Path/Component key.
6.8.2 SEARCHING FOR A CODE
If a code for your component is not listed in Appendix A:
1. Turn the component on (e.g. TV).
2. Press the matching Path/Component key (e.g. TV).
3. Press and hold LEARN until the LED flashes twice.
4. Press 9, 9, 1.
5. Aim the remote towards the TV, and alternate between pressing and TV.
6. Stop once the TV turns off. Immediately press and release LEARN to lock the code.
7. If, for future reference, you want to know what the code is, press and hold LEARN until the LED
flashes twice and then press 9, 9, 0, 1. Wait 3 seconds and count the number of flashes. The number
of flashes represent the first digit (i.e. 3 flashes = 3, no flash = 0). Next, press 2 for the second digit,
3 for the third digit, and 4 for the fourth digit, and count the number of flashes each time. Record this
code number in Appendix A for future reference.
6.8.3 VOLUME LOCK
After entering a code for your TV or satellite receiver, you may find it inconvenient to switch the
Path/Component keys back and forth when you alternate between say, changing channels on your TV and
adjusting the volume of MAIN (AVM 20). Not to worry, the Volume Lock feature takes care of this. When
engaged, the volume keys adjust MAIN volume, regardless of which Path/Component is selected. You can
then leave your Path/Component selection in TV and no longer have to press MAIN first to adjust the volume
of the AVM 20.