Anthem AVM 20 v2 - Manual (Page 71)

64
Example 2: Restore Installer Settings.
Note: FM • AM Tuner presets that were saved in INSTALLER SETTINGS will also be restored.
• Enter the Setup (section 7.1). Go to ‘11. SAVE/RESTORE SETTINGS’ and press SELECT.
• Press the button until you reach ‘d. RESTORE INSTALLER SET’NS’.
• Press SELECT. You will be asked to confirm that you want to restore installer settings.
• Use the buttons to change to ‘Yes’ and press SELECT. On-Screen display message will then say
‘Saving Successful’, the Front Panel display will say ‘Done!’.
• When finished, press to go to another menu item, or...
• Press BACK to leave the submenu and return to the main menu.
Example 3: Reload Factory Defaults.
Note: The current time and FM • AM Tuner presets will be retained. Surround mode level, balance,
bass/treble adjustments (sections 5.6 and 5.7), and Modes (section 5.8) will be reset to +0.0 dB.
• Enter the Setup (section 7.1). Go to ‘11. SAVE/RESTORE SETTINGS’ and press SELECT.
• Press the button until you reach ‘e. RELOAD FACTORY DEFAULTS’.
• Press SELECT. You will be asked to confirm that you want to ‘reload factory settings’.
• Use the buttons to change to ‘Yes’ and press SELECT. On-Screen display message will then say
‘Saving Successful’, the Front Panel display will say ‘Done!’.
• When finished, press to go to another menu item, or...
• Press BACK to leave the submenu and return to the main menu.
7. SETUP MENU
continued …