Anthem AVM 20 v2 - Manual (Page 59)

52
7.4.5 SOURCE SETUP / PRESETS
For each Source, you can change the name and, where applicable, assign digital audio and component video
input, assign speaker configuration, adjust equalization, and set audio group delay. You can also pre-select
surround modes that take effect for each Source when the AVM 20 is turned on, or a Source is selected. This
is particularly useful when you have changed Mode settings for a particular program. When another member
of your family uses the AVM 20, presets are recalled, ensuring trouble-free operation.
For the following example, highlighting ‘f. DVD’ in menu 5 and then pressing SELECT displays this menu:
Rename Source:
The factory assigned Source names that appear on the Front Panel Display and the On-Screen Display can
be changed to another name, up to six characters long. The following characters are available:
A, B, C....Z, a, b, c....z, blank, dash (–), period (.), slash (/), 0, 1, 2....9.
After highlighting the RENAME line, press SELECT and use the buttons to move from character to
character, then use the buttons or rotate the Master Control Knob to change the character.
Note: It is also possible to rename ‘ZONE2’, ‘ZONE3’, and ‘RECORD’ – see section 7.4.8.
7. SETUP MENU
continued …
5. SOURCE SETUP / PRESETS
a. CD
b. 2-Ch
c. 6-Ch
d. TAPE
e. FM/AM
f. DVD
g. TV
h. SAT
i. VCR
j. AUX
5f. DVD SETUP / PRESETS
a. RENAME : DVD
b. AUDIO IN : Dig RCA DVD
c. EQ : LF +0.0 dB HF +0.0 dB
d. SPEAKER CONFIG : Cinema
e. COMPONENT VIDEO : Comp1
f. AUDIO GROUP DELAY : 0.0 ms
- - - - - - - MODE PRESETS - - - - - - -
g.
2-Ch : AL-Cin
h. DD-2.0 : Same as 2-Ch
i. DD-5.1 : +Last THX Used
j. DTS-5.1 : +Last THX Used
k. DD-EX : Auto
l. DTS-ES : Auto