Flaming River Camaro Rack & Pinion Cradle Kits 1970-81 - Manual (Page 11)

70-81 Camaro Rack & Pinion Cradle System
70-81 Camaro
Rack & Pinion Steering
100808 revised
10
4) To install the outer tie rod ends into the spindles you must load the front suspension. (Securely placing
jack stands under the lower control arms and lowering the car onto the jack stands accomplishes this.)
Install the outer tie rod ends into the spindle and tighten the castle nuts to 30-40 ft lbs. Make sure to
install cotter pins into the castle nut and tie rod end and bend the tabs over for security.
Universal Joint System.
1) Install support-bearing mount onto the rear control arm bolt; after the shafting is installed make sure to
tighten the set screw.