Flaming River Chevelle/El Camino Rack and Pinion 1968-72 - Manual (Page 14)

Rack & Pinion Cradle System
68-72 GM A Body
Power Steering
01/15/07
12
Universal Joint System.
1) Install support-bearing mount onto the rear control arm bolt. (Picture below). Note: The angle of this
mount is set for most applications. Some adjustment may be necessary for the correct angle and u-
joint alignment.
2) We recommend the use of ¾” wood dowel rod to mock up the steering shaft to obtain the correct
length of the shafts.
3) Install your shaft kit and snug each set screw so that it will leave a mark in the shafts.
4) Remove shaft and dimple each setscrew mark using a ¼” drill bit. (As shown below.)
Continued on Next Page