GReddy TURBO KITS: Honda Civic Si 2002-05 / T517Z - Manual (Page 13)

• Reinstall the heat shield and make sure
there are enough clearance between the
hose and the shield and the drive shaft.
* Oil return hose to heat shield: 10mm
* Oil return hose to drive shaft: 20mm
Important!
With out this proper clearance, there is a
possibility of the return hose to fail and can
cause fire and damage the engine.
3-8
Compression Pipe Installation
(1) Install Compression pipe C-1 to the out
let of the turbo using provided gasket
and hardware.
(Parts used #6, 42, 63)
(2) Loosen the hose clamp on the Radiator
hose and rotate the hose so it comes up
slightly.
(3) Install compression pipe C-2, and C-3
between C-1 and throttle body. Using
provided hose and clamps.
* Secure the bracket on C-2 to the factory
air cleaner box mounting point.
* Make sure that the compression pipes
does not interfere with shifter linkage
movement. Also, check the clearance
between the radiator hose and
compression pipes.
(Parts used #7, 8,32, 33,34, 38,39,
40,58)