Night Owl STA-88 - Manual (Page 100)

99
Config
Changing Channel Information
To change the channel information select Config, select Device Manage,
and select the device where you would like to change information on the
channels. You can either double left click on the channel or highlight the
channel and select the Change button.

Channel: This will indicate the channel that you are configuring.

Name: This will be the name of the channel that will be displayed.

Protocol: This should be set to TCP or UDP depending on the
router that the DVR is connected to. If you are unsure, contact your
Internet Service Provider.

Stream Type: Choose either Compound stream or Video Stream.

Alarm Time Len(sec): This is the time between alerts in seconds.

Pop-up Live: This will expand the channel where an alarm has
been triggered to a full screen live image.

Volume: This will play a sound (warning volume under path
parameters) when the alarm is triggered.

Capture: This will take a snapshot when an alarm is triggered.

Record: This will begin recording when an alarm is triggered.

Apply to: This will apply all of the changes to the current channel or
all channels.
Chapter 22 Control Management Software (CMS)