Figure 10, Installation – Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual User Manual

Page 25

Advertising
background image

Installation

Lift the Mounting Plate
above the wall bracket.

Secure the Mounting Plate to the

wall at the 3 locations shown

below.

Slip the top of the
Mounting Plate over
the angled lip of the
wall bracket.

Secure the Mounting Plate to the wall

at the 3 locations shown here.

Figure 10

Attaching the Mounting Plate to the Mounting Bracket

900-0095-01-00 Rev A

23

Advertising
See also other documents in the category Outback Power Systems Power suppliers: