Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual - Manual (Page 47)

Operation
Setting Charging Parameters
If changes need to be made to charging parameters, follow the menu map below.
IMPORTANT:
Access the Advanced
Menu as instructed on
page 43.
WARNING: Explosion Hazard
NEVER equalize a sealed battery.
Consult the Battery Manufacturer
for exact charging requirements.
IMPORTANT:
4. Continue pressing <DOWN> to
cycle through all the settings.
To Set Charging Limits:
1. Press the <CHGR> Soft Key.
2. Press the <INC> or <DEC> Soft
Key to change the parameter.
3. Press <DOWN> to advance to
the next parameter.
 press the <MAIN> soft key to return to the Main page.
 press <ADV> to return to the “Choose Device” Screen, or
When the screen reads “Charger Programming Completed”,
 press <TOP> to return to the “Choose Category” Screen, or
Figure 32 Setting Input Source and Current Limit
900-0095-01-00 Rev A
45