Outback Power Systems FLEXpower ONE One Fully Pre-Wired Single Inverter System Installation Manual - Manual (Page 37)

Installation
Reassembling the Enclosures
Lip
Slot
Raceway
FM80
Front
Cover
Cabling not shown.
Mounting
Panel
To Replace the Raceway:
1. Slip the lip on the Raceway into the
slot on the mounting panel.
2. Align the holes on the bottom of
the Raceway with the holes
provided on the mounting panel.
3. Secure the Raceway in place with
the screws provided.
To Replace the FLEXmax 80
Front Cover:
1. Align the holes on the FM80
Front Cover.
2. Secure the FM80 Front Cover in
place with the screws provided.
Figure 21 Replacing the Raceway and FLEXmax 80 Front Cover
Cabling not shown.
Inverter’s AC Terminal
Access Cover
To Replace the Inverter’s AC
Terminal Access Cover:
1. Align the holes on the sides of the
cover with the holes on the inverter.
2. Secure the cover in place with the
screws provided.
Figure 22 Replacing the Inverter’s AC Terminal Access Cover
900-0095-01-00 Rev A
35