Pop & Lock PL1800C - Manual

Step 1: Remove the access panel from the
inside of the tailgate. (You may have to remove
the bed liner cover if applicable) Step 2: Remove the latch rods for the factory
handle by rotating of the plastic rod clips and
pulling the rods up and out of the clips. Step 3: Remove the handle mounting bolts
from the factory handle .
Step 4: Lift the tailgate into the up position but
do not fully engage in the latches. While sup-
porting the tailgate with one hand, pull the bot-
tom of the handle out first, then carefully pull
out the handle assembly from the top. Step 5: Install the Pop & Lock into the tailgate
in reverse (step 4-3-2) while making sure that it
is in the locked position (fig. 1). Make sure that
the bottom small tabs (fig 2) snap onto the tail-
gate before tightening the bolts. Step 6: Test the lock before installing access
panel. Reinstall the access panel (and the bed
liner cover if applicable).
Contents:
Lock Assembly, 2 keys and Instructions. Tools Required:
Philips screwdriver, Ratchet,
10 mm Socket, Ratchet extension. Technical Support:
Call 1-800-342-5911
[email protected]
Installation Instructions
Tailgate Lock PL1800, PL1800C Chevrolet Luv Dmax 2005 - Up
Locked
Unlocked
Fig. 1
Fig. 2