Pop & Lock PL9000 - Manual

PL9000 – Power Pop
Universal Keyless Entry
System Tonneau Cover
Installation Instructions
Actuator
Actuator Bracket
1) Replace both of the existing rotary latches on
the tonneau cover with the new supplied power
adaptable rotaries. Install both Actuator Brackets
with the supplied Bracket Bolts. Install both Linkage
Rods by sliding them into the grooves in the rotary
latch cable clamps, then hook the end of the linkage
rods through the holes in the end of the
Actuators
and bolt the Actuators to the Actuator Brackets with
the supplied Actuator Screws (there is a tab on the
Actuator Bracket that only allows the Actuator to be
mounted on one way). You may also need to install
new strikes which are also supplied.
2) Mount Keyless Receiver to tonneau cover centered between the rotary latches. Be sure to use proper length screws
and only screw into the thick portions of the tonneau as to not protrude the outer surface of the tonneau cover.
Power Adaptable Rotaries