Posey KeepSafe® Essential - Manual (Page 10)

10 KeepSafe ® Essential

Setting Alarm Tone
The KeepSafe Essential has five (5) available tones. This allows you to differentiate between patients and
other equipment alarms.
To Select Tone:
1. Ensure alarm is on and magnet is on face plate.
2. Remove the battery compartment door by sliding down to gain access
to the programming buttons.
3. Press TOnE button (fig. 5) to scroll through the tone selections.
4. Alarm mode must be set to either “Voice and Tone” or “Tone” (see
page 9) in order to hear the selection.
5. Each time you press the button, tone will change and a two (2) second
sample plays. The last sample heard is the tone utilized for the alarm
when the magnet is removed from the face plate, depending on which
monitoring mode is selected.
6. Replace the battery door and slide shut, locking into place.
NOTE: Cat. 8373nP does nOT have an On/OFF switch. To set Alarm Tone
for Cat. 8373NP, follow all steps above except step 1.
Tone Volume
Voice
&
Tone
Voice Tone
Qt
y
4A
AA
A
lk
ali
ne
AN
SI-
24
A I
EC
-L
R0
3
ty
4
AAA
Fig. 5