Posey KeepSafe® Deluxe - Manual (Page 17)

KeepSafe ® Deluxe 17

Wall Mount
1. Choose a location out of the patient’s reach, but with indicator lights in clear view of staff.
2. Use wall/chair bracket (Cat. No. 8276 (without wire clip), (fig. 15).
3.
Screw attachment:
• Position wall bracket with back (flat side) against wall (fig. 15).
• Using bracket as a guide, mark spots to insert anchors into wall.
make sure it is safe to drill and there are no pipes or electrical wires that could be
damaged.
• Drill holes where marked and insert anchors.
• Position bracket over holes. Insert and tighten screws.
4. Slide alarm onto bracket from top down until it is firmly in place.
5. To remove alarm, gently push release lever IN while sliding alarm up and out (fig. 16).
6. Make sure sensor and/or nurse call cables can be secured out of the way and do not present a tripping
hazard.
Fig. 16 - alarm/Bracket
(Front View)
RElEaSE lEVER
HOLD/SUSPEND
SliDE
alaRm
uP
Fig. 15 - Chair/Wall
Bracket (Front View)
RElEaSE
lEVER
SCREW
hOlES