Posey Bed 8060 - Manual (Page 11)

Posey Bed - 8040, 8050, 8060 11

Top Piece Installation (8060 Model)
Materials:
• Part C1
NOTE: Leave pre-installed Corner Pads in place.
1. Place the Top Piece (Part C1) section into the
Metal Retainers on the head of the A-Frame
Legs (Fig. 14).
NOTE: For one-person set-up, insert the Top
Piece one end at a time.
2. Push the Silver Metal Detent Pin into the top
hole (Fig. 15).
NOTE: Make sure the Silver Metal Detent Pin
protrudes out through the hole on the Metal
Retainer.
Bottom Hole
Top Hole
Corner Pads
Fig. 14
Bottom Hole
Top Hole
Corner Pads
Fig. 15
3. Repeat Step 2 for the other side of the
assembled A-Frame Legs.
NOTE: The Top Center Piece must be able to
slide freely so that the frame can move as the
bed articulates.
The bed may not always fit
through some doorways. In this situation, lower
the top piece to the lowest position, pushing the
Silver Metal Detent Pin into the bottom hole
(Fig. 14), and then return it back to the top hole
after transport.
Bed Assembly