Posey Bed 8060 - Manual (Page 21)

Posey Bed - 8040, 8050, 8060 21

4. Repeat Steps two and three on the other side
of the IV post.
5. Insert the two IV Post Mount Brackets inside
the IV post (Fig. 47).
6. Tighten the top Allen Head Screw using the
3/16” Allen Wrench (provided) (Fig. 48). The IV
Post Mount Bracket must be tightened so it
does not move during bed articulation.
7. Repeat on the other side.
8. Tighten the side Allen Head Screw (Part M)
(Fig. 49).
9. Repeat this step on the other side.
10. Repeat steps one through ten on the other end
of the bed.
Installing the IV Post Mount Bracket
(Part Q) from the Top
1. Position the Slider Bar (Part D) above the IV
post opening (Figs. 42 and 43)
NOTE: The location of the Slider Bar my
be either in front of or behind the IV post
depending on the location and design of the
head and/or footboard. Figure 42 shows the
Slider Bar and IV Post Mount Bracket installed
in front of the IV post. Figure 43 shows the
Slider bar and IV Post Mount Bracket installed
behind the IV post.
2. Attach the IV Post Mount Bracket (Part Q) to
the Slider Bar (Fig. 44).
3. Align the IV Post Mount Bracket with the IV
post opening (Fig. 45) and align the wedge of
the bracket (Fig. 46).
Fig. 43
Fig. 45 Fig. 46
Fig. 44
D
Fig. 42
D
Fig. 47
Fig. 49
Fig. 48
Q
Q
Bed Assembly