Vaisala Calibration of Series HMDW6070 and HMP140 Transmitter with HMI41 - Manual (Page 23)

HMI41 Calibration Option
Appendix 1
19116ZZ-U218en-1.1
2 1996-08-26
2. Scale selection modes
The HMI41 automatically assumes the function selected in the setup menu
when it is turned on again with the ON/OFF button. In the following, you will
find a summary of the scale selection modes.
DISPLAY DESCRIPTION
RH
setminmax hyst hold Lo batHi
Pabs Pa g/m
T
Td °C°F
°C°F
%
The HMI41 has been turned on.
Indication of the software version (if the version
is 1.02 or more)
bat Hi
Indication of the battery voltage.
RH
T
Press any button except ON/OFF within 5
seconds to enter the scale selection modes.
Select the desired scale selection mode with
buttons ▲or ▼ and acknowledge the selection
with ENTER. Then follow the instructions of
tables 2.1 - 2.5 accordingly.
2.1 Voltage output scale selection mode (U)
DISPLAY WHAT TO DO PRESS:
Select the voltage output scale selection
mode (U)
▲ (number up) or
▼ (number down)
ENTER to acknowledge the
selection
set Lo
T
T °C
°C
Set the lower limit of the temperature
range
▲ (number up) or
▼ (number down)
ENTER to acknowledge the
selection
set Hi
T
T °C
°C
Set the upper limit of the temperature
range
▲ (number up) or
▼ (number down)
ENTER to acknowledge the
selection
ON/OFF