Vaisala HMT140 - Manual (Page 43)

Additional Settings
M211488EN-C 35
Alarm-triggered Transmission
The HMT140 has the ability to initiate a Transmit Attempt
based on an alarm, if this functionality is configured in
Vaisala viewLinc.
An alarm can be triggered either when the measured value
exceeds a high threshold or goes below a low threshold for a
period of time, as configured in viewLinc.
The HMT140 can also be configured to initiate a Transmit
Attempt when it exits an alarm state. Refer to the Vaisala
Veriteq viewLinc Administrator Guide for information about
alarm settings.
Additional Settings
Change Input/Output Scale
If you want your device to provide more meaningful output
measurement units, you can modify the output settings (if
you are not sure if your network requires/supports this
option, contact Vaisala Canada for assistance).
To modify input/output values:
1
From the Setup tab, select the I/O Definition tab.
2 Enter the device’s input range values.
3 Enter required Display Units, the number of decimal
places you want recorded, the high/low output values
and desired measurement units.