Vaisala HMT140 - Manual (Page 55)

Removing and Fastening the Probe
M211488EN-C 47
Figure 16: Fixed Probe Model
The following numbers refer to Figure 16:
1 Locking bushing
2 Holder bushing (attached permanently to the probe)
3 HMP110 probe
Remote Probe Model
To remove and replace a remote probe:
1
Unscrew the small sleeve at the end of the probe cable
that secures the probe in place, and pull out the probe.
2 Replace the probe and screw the small sleeve back on,
securing the probe tightly in place.
1
3
2
1
3
2