Vaisala DMT143 - Manual (Page 40)

USER'S GUIDE ____________________________________________________________________
38 ___________________________________________________________________ M211435EN-E
List of Serial Commands
All commands can be issued either in uppercase or lowercase. In the
command examples, the keyboard input by the user is in bold type.
The notation <cr> refers to pressing the carriage return (Enter) key on
your computer keyboard. Enter a <cr> to clear the command buffer
before starting to enter commands.
Table 7 List of Serial Commands
Command Description
<ESC> Stop the continuous outputting of RUN mode
or R command
? Show device information
?? Show device information (overrides poll mode)
ADDR [0 … 255] Show or set transmitter address
AERR Set analog output error level
ALARM Set dewpoint level for LED alarm
AMODE Show analog output mode
AOUT [ON/OFF] Enable or disable analog output
AOVER [ON/OFF] Allow analog outputs to exceed their range 10%
ASEL Set analog output parameter and scaling
ATEST Test analog output
CLOSE Close the temporary connection and return the
device to POLL mode
ERRS Display the currently active errors
FILT [0 ... 1] Set output filtering level
FORM [modifier string] Set output format
FRESTORE Restore factory settings
GAS [0 ... 1] Set measured gas type
HELP Show list of currently available serial commands
INTV [0 ... 255 S/MIN/H] Set the continuous output interval
(for RUN mode and R command)
L Show user adjustment values
LI Set user adjustment values
OPEN [0 … 255] Open a line to transmitter at defined address
PRES [0.001 ... 50] Set permanent pressure compensation value
R Start the continuous outputting
RESET Reset the transmitter
SDELAY [0 … 255] Set response sending delay
SEND [0 … 255] Output readings once
(specify address for transmitters in POLL mode)
SERI [baud p d s] Show or set the serial interface settings
SMODE [mode] Show or set startup serial mode:
RUN, STOP, or POLL
SNUM Display transmitter serial number
SYSTEM Show transmitter firmware information
TIME Show transmitter uptime
UNIT [m/n] Select metric or non-metric units
VERS Show transmitter firmware version
XPRES [0.001 ... 50] Set temporary pressure compensation value