Vaisala DMT143 - Manual (Page 57)

Chapter 5 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 55
Set Serial Line Response Time
With the SDELAY command you can set delay (response time) of the
serial line, or view the currently set delay value.
SDELAY [delay]<cr>
where
delay = Serial line delay, range 0 … 255. One unit of delay
corresponds to 4 milliseconds.
Example (set delay to 120 milliseconds):
sdelay 30
Serial delay : 30
Other Commands
Opening the Transmitter in POLL Mode
Use the OPEN command to connect to a transmitter that is in POLL
mode.
OPEN [address]<cr>
where
address = Transmitter address, range 0 ... 255.
Example (target transmitter in POLL mode, with address 5):
open 5
DMT143 5 line opened for operator commands
Closing the Connection to a Transmitter
in POLL Mode
The CLOSE command closes the connection to a transmitter.
CLOSE<cr>
Example:
close
line closed