Vaisala WMT700 - Manual (Page 25)

Chapter 3 _________________________________________________________ Retrofit Installation
VAISALA _______________________________________________________________________ 23
4. Attach the WMT700 sensor body to the WS425 mounting kit and
tighten the bolt.
5. Remove the transportation damper protecting the array and store it
for future use.
6. Connect the cable to the data acquisition system and power supply.
Connect the wires according to section Wiring on page 25.
WMT700 is now ready for operation.
1103-054
Figure 9 Tightening the Connector
The following number refers to Figure 9 above:
1 = Tighten the connector by rotating the ribbed part of the connector
by hand. DO NOT USE TOOLS.
NOTE Verify that the connector is properly tightened to avoid water leakage and
damage to the sensor. If water leaks into the connector, this voids the
warranty for WMT700.