VariZoom VZCINEMAPRO-K2 - Manual (Page 22)

- 21 -
17. Options and Specs
Additional Software- The Cinema Pro head can operate as a slave to Kuper Node
motion control software, and is also is capable of providing motion data for virtual set
operation.
Data capture software is available, for data sharing. This will allow you to export the
data from the Cinema Pro to a personal computer.
Additional Head options-
The Cinema Pro head can be fitted with either a 100mm half ball, or Mitchell mount. A
Mitchell ring adapter is available for old style Mitchell mount.
An adapter is also available to adapt Mitchell mount to Jimmy Jib style mount.
Wireless control is available, and can controlled from up to ¼ mile. Up to 1 mile line of
sight.
Additional controller cables are available in 50’ or 100’ increments. A male to female
LEMO coupler is available to join the cables.
Cinema Pro XLR power cables are available in 30’ or 75’ increments.
2” head extension blocks are available, and will increase the underslung clearance range
from 16.5”-18.5” to 18.5”-20.5”. A maximum of two can be installed. This will also
increase clearance if using a larger lens.
¼” or 1/8” nodal line offsets can be installed on the Cinema Pro’s camera mounting plate
to line of the center of the lens when necessary.
Dedicated video sliprings can be fitted on the Cinema Pro head to allow high quality SD
video to pass through the head. There is a 2db signal loss through this dedicated slip
ring, so HD SDI is not supported unless a line driver is introduced. This option will only
support HD for monitoring purposes – the signal will not be of broadcast quality.
HD hardwiring is available for a broadcast-quality HD video signal. (This cable will
bypass the slipring, and limit pan and tilt movements to 720°)
Specs-
Head construction: Primarily Aluminum, with carbon fiber platform rails and some
stainless steel, steel, brass, bronze components
Height: 19.5”
Width: 12”
Depth: 6”