System, Comm set, Password set – Videoswitch CMOR Vi-D5000 Dome User Manual
Page 28: Dome, Preset, Scan, Vi-d5000 ir dome
Vi-D5000 IR Dome
Videoswitch Page
23
VD601A.DOC
4.2 System
•
PROTOCOL:
Display the protocol of the dome
•
COMM:
Communication parameters: Baud rate, Parity ,bit, Data bits, Stop bits.
•
DOME ID:
Display the dome address. The range is 000-255.
•
MODULE:
Display the brand and model of camera.
•
VERSION:
Firmware version of dome.
•
<COMM SET>
Set comms parameters in this menu instead of using DIP switches
•
<PASSWORD SET>
Set passord to protect menu
4.2.1 Comm
Set
•
DEVICE ID:
It is only in the menu and used to distinguish different domes with the same
Addresses.
•
CHECK ID:
Enter the displayed DEVICE ID. This then allows you to set Address and
Baud Rate of this particular dome via the menu instead of using the DIP
switches.
•
TARGET ID:
Address can be changed and edited on line. It will be effective
immediately.
4.2.2 Password
Set
• SET
PASSWORD1: 8888
• SET
PASSWORD2: 8888
•
PASSWORD ENABLE: ON or OFF
4.3 Dome
4.3.1 Preset
•
PRESET NUM:
Select the preset number needing to be operated, whose range is
001-220.
•
CALL PRESET:
Call the preset number edited.
•
<SET PRESET>
Enter SET PRESET, move to required location and use call preset 1 to
save or call preset 2 to exit.
Note
Because some presets are used to realise special functions, they can not be set and called normally.
4.3.2 Scan
•
SCAN SPEED:
Scan speed range is 1 – 9
•
SET A POS:
Set left boundary. The range between left and right boundary is 20 - 340°
•
SET B POS:
Set right boundary. The range between left and right boundary is 20 - 340°