Videoswitch CMOR Vi-D5000 Dome - Manual (Page 29)

Vi-D5000 IR Dome
Videoswitch Page 24 VD601A.DOC
• A/B SCAN Scan between A and B points
• 360° SCAN Scan through 360°
4.3.3 Guard Tour
This dome camera can set 4 groups of guard tour. Each group has 16 points and each point can be set alone
the dwell time and tour speed.
• GUARD TOUR ID: Select group 1 - 4
• CALL GUARD TOUR: Call the guard tour ID edited successfully.
• <SET GUARD TOUR> ID: The tour sequence of guard tour group. Its range is 1-16.
• POINT: The preset of guard tour. Its range is 01-64 settable.
• TIME: The default time of all points is 05s. Its range is 05-60s.
• SPEED: The speed between two points in each guard tour group can be set alone.
Its range is 1-64 grades.
Note
Preset 33 and 34 cannot be set as a guard tour point.
4.3.4 Pattern
• PATTERN ID: Factory default is 1. Select the pattern needing to be edited. 1-4 pattern are
effective.
• CALL PATTERN: Call the patterns having been edited.
• <PATTERN> Enter the pattern set. “XXX” means the quantity of operator’s running
pattern, and 512 is the most amount of the instruction.
Note
The precision of pattern is associated with the system settings and the module of camera. When using the
pattern, the user is recommended to turn off the privacy zone and unnecessary display function.
4.3.5 Privacy Zone
• EDIT MASK NUM: Select the mask number. It depends on the module supported.
• SET MASK: For detailed steps, please refer to the “Example of Setting Mask 1”.
• MASK: ON and OFF are selectable.
Example of Setting Mask 1
1. Move the cursor to EDIT MASK NUM, which is be selected by pressing the right key of direction.
2. Press the “up and down” keys in the keyboard to edit the mask number as 1, which is be entered
by pressing the right key. “-” means selecting this mode, while “ ” hourglass symbol, means
editing this mode.
3. Move the cursor to <SET MASK> and press right key to set the position of privacy zone. See the
figure on the left below.