Zoo Med AquaSun® Dual Timer - Manual (Page 2)

(figure 1)
Grounded
3 Pronged Plug
and GFCI Receptacle
GFCI
ZOO MED LABORATORIES, INC. 3650 Sacramento Dr. • San Luis Obispo, CA 93401 U.S.A. • Phone: 805-542-9988 • E-mail: [email protected]
www.zoomed.com
PROGRAMMING and OPERATION of YOUR TIMER: (continued)
PLUG THE TIMER INTO A GROUNDED GFCI (Ground Fault Interrupted Circuit) OUTLET:
To reduce the risk of electric shock, this timer has a three-prong plug and
must be plugged into a grounded three-prong receptacle. The receptacle
must also be GFCI protected. If you are unsure about the electrical supply
and connection, contact a qualified licensed electrician. See figure 1.
DRIP LOOP: This timer must be used in a grounded receptacle
with a “drip loop”. The drip loop will prevent water from running
along the power cords and getting the timer outlet or wall
receptacle wet. To create a drip loop, be sure that a portion of
each power cord is lower than the level of the wall receptacle as
shown in figure 2. If for any reason the plug or wall receptacle
gets wet, do not grasp or unplug the power cord until after the
power has been switched off at the main fuse or circuit breaker.
WARRANTY:
Zoo Med Laboratories, Inc. (Zoo Med) warrants this product to be free of defects in material and workmanship under normal use and service for one
year from the date of purchase. The obligation under this warranty is limited to the repair or replacement, at Zoo Med’s discretion, of the product or
any part thereof, when the product is returned to Zoo Med, freight prepaid. No claim shall be allowed under this warranty if, in the opinion of Zoo Med,
this product has been subject to accident or improper usage, including but not limited to: water damage, improper storage, accidental dropping, etc.
This warranty is in lieu of all other warranties and representations express or implied. Please include your receipt, full name, address, phone number,
and email address along with a note explaining failure when sending any product back to Zoo Med. Please allow 4 to 6 weeks for repair
or replacement.
(figure 2)
Drip Loop
GFCI
GFCI