DME Chill Vents - Manual (Page 2)

D-M-E CHILL VENT BY NGK Specification No. ME-080065-999(C)
VPS9999 Page 2 of 2
CHILL VENT INSERT — COMPONENT DETAILS
Installation Notes:
•
10mm DIN Ejector
Pin to be used with
this product
• Key slots provided
on product as shown.
Toolmaker is
responsible for
keying product.
• Tap threads are
provided in product
for retaining screws.
Customer to supply
screws.
• Customer to supply
NPT pipe fittings.
High-temperature pipe
thread sealant is
recommended to be
used with this product.
• Once installed, Chill
Vent insert halves
must align properly to
achieve good seal-off
between mating
surfaces. Use a blue-
off compound to check
for proper fit. Adjust
shim pack accordingly
during installation until
desired mating seal-off
is achieved.
Dimensions shown are in
millimeters (inches).
NOTICE:
D-M-E shall not be liable
for misuse or failure to
follow the enclosed
instructions and
specifications. D-M-E
hereby disclaims all
implied warranties,
including merchantability
and fitness for a particular
purpose. In no event shall
D-M-E be responsible for
loss of use, revenue or
profit, or for incidental or
consequential damages.
D-M-E Company
29111 Stephenson Highway
Madison Heights
Michigan 48071 USA
USA 800-626-6653
CANADA 800-387-6600
For more information on our
products, please visit our
website at www.dme.net
BOTTOM HALF
TOP HALF
1/4-18 NPT
Thread Depth
= 11.0 (0.43)
1/4-18 NPT
Thread Depth
= 8.0 (.32)
(2)
1/4-18 NPT
Thread Depth
= 8.0 (.32)
(2)
1/4-18 NPT
Thread Depth
= 11.0 (0.43)
6.00
[.236]
6.00
[.236]