Kenwood KDC-U7056BT - Manual (Page 30)

60 | KDC-U7056DAB/ KDC-U7056BT/ KDC-U7056BTL English | 61
General settings
12-5. Initial settings
You can configure initial settings of this unit.
1 Press [SRC] to select a Standby (“STANDBY”).
Refer to
<Source selection> (page 10) .
2 Press [Control] knob.
Enters the Function setting mode.
3 Select “Initial Settings” using [Control] knob.
For how to use [Control] knob, refer to
<3-3. How
to select the item> (page 9) .
4 Select an Initial setting item using [Control]
knob.
Display Description
“SRC Select” Set source selection method.
“ 1 ”: The source switches each time [SRC] is
pressed.
“2”: Press [SRC], Turn [Control] knob to select
the source, and then press [Control] knob to
determine it.
“Key Beep” [4] Setting the operation check sound (beep
sound) ON/OFF.
“ ON ” / “OFF”
“TDF Alarm” [4] If you turn off the engine key of the vehicle
without removing the panel, a beep sounds
for 30 seconds.
“ON” / “ OFF ”
“Chinese” [1] When this is set to ON, the following character
strings are displayed in Chinese:
Folder name/ File name/ Song title/ Artist
name/ Album name
“ON” / “ OFF ”
“TAG Language” [2] When this is set to “Arabic”, ”Persian”, or “Thai”,
the following character strings are displayed in
Arabic, Persian, or Thai:
Folder name/ File name/ Song title/ Artist
name/ Album name
English / Arabic / Persian / Thai
“Function Language”
[2]
Changes the display language of items
displayed in the Function setting mode.
English / Arabic / Persian
“Pandora Source” [1][3] Sets whether to display Pandora during source
selection.
“ ON ” / “OFF”
“aha Source” Sets whether to display aha during source
selection.
“ ON ” / “OFF”
“Built-in AUX” Sets whether to display AUX during source
selection.
“ ON ” / “OFF”
“CD Read” Sets the method for reading CD.
When unable to play a special format CD, set
this setting to “2” to force playing. Note that
some music CDs may be unplayable even
when set to “2”.
In addition, audio files cannot be played when
set to “2”. Normally, keep this set to “1”.
1 : Automatically distinguishes between the
audio file disc and music CD when playing
a disc.
2: Forces playing as a music CD.
“Built-in AMP” Selecting “OFF” turns off the built-in amplifier.
Turning off the built-in amplifier improves the
quality of the sound from Preout.
“ ON ” / “OFF”
“F/W Update” Upgrades the firmware.
Selecting “YES” and then pressing [Control]
knob starts upgrading the firmware.
For how to update the firmware, access our
web site.
http://www.kenwood.com/cs/ce/
( Colored text : Factory setting)
[1] Function of KDC-U7056BT.
[2] Function of KDC-U7056BTL.
[3] Function of KDC-U7056DAB.
[4] Not displayed while using 3 way system.
5 Select a setting using [Control] knob.
Returns to the previous item.
Exiting from the Function setting mode
Press and hold [ 1/6].