Kenwood NX-420 - Manual (Page 11)

3
INSTAllING/ rEMOvING AlKAlINE BATTErIES (OPTIONAl
BATTEry CASE)
◆ Do not install batteries in a hazardous environment where
sparks could cause an explosion.
◆ Never discard batteries in fire; extremely high temperatures can
cause batteries to explode.
◆ Do not short circuit the battery case terminals.
◆ Do not use rechargeable batteries.
Note:
◆
If you do not plan to use the transceiver for a long period,
remove the batteries from the battery case.
◆ This battery case has been designed for transmitting at a
power of approximately 1 W (the low power setting on your
transceiver). If you want to transmit a stronger signal (using
the high power setting on your transceiver), use an optional
rechargeable battery pack.
1 To open the battery case, press on the
two tabs on the upper rear of the case,
then pull the two halves apart.
2 Insert 6 AA (LR6) Alkaline batteries into
the battery case.
• Be sure to match the polarities with those
marked in the bottom of the battery case.
3 Align the tabs of the cover with the base,
then push down on the cover until it
locks in place.
INSTAllING THE ANTENNA
Screw the antenna into the connector on the
top of the transceiver by holding the antenna
at its base and turning it clockwise until
secure.