Kenwood NX-420 - Manual (Page 20)

12
BASIC OPErATIONS
SwITCHING POwEr ON/OFF
Turn the Power switch/ Volume control clockwise to switch the
transceiver ON.
Turn the
Power switch/ Volume control counterclockwise fully
to switch the transceiver OFF.
■
Transceiver Password (Types I and II Only)
If your transceiver is password protected, you must first
enter the password before you can use the transceiver.
1 Rotate the Selector to select the first digit of the
password.
2 Press the S or key to accept the entry and move to
the next digit.
• Press the A or # key to delete an incorrect digit.
3 Repeat steps 1 and 2 to enter the entire password.
• The password can contain a maximum of 6 digits.
4 Press the S or key to confirm the entered password.
• If you enter an incorrect password, an error tone sounds
and the transceiver remains locked.
ADJUSTING THE vOlUME
Rotate the Power switch/ Volume control to adjust the volume.
Clockwise increases the volume and counterclockwise
decreases it.
SElECTING A ZONE AND CHANNEl/GrOUP ID
Select the desired zone using the key programmed as [Zone
Select] or [Zone Up/Down]. Each zone contains a group of
channels.
Select the desired channel/group ID using the
Selector knob
(default). Each channel/group ID is programmed with settings
for transmitting and receiving.