Kenwood NX-420 - Manual (Page 22)

14
rECEIvING
Select the desired zone and channel. If signaling has been
programmed on the selected channel, you will hear a call only
if the received signal matches your transceiver settings.
Note: Signaling allows your transceiver to code your calls. This will
prevent you from listening to unwanted calls. Refer to “SIGNALING”
on page 24 for details.
■
receiving Group Calls (Digital)
When you receive a group call on a Conventional channel
and the received group ID matches the ID set up on your
transceiver, you can hear the caller’s voice.
When you receive a group call on a Trunking channel, the
transceiver automatically switches to the communications
channel to receive the call.
■
receiving Individual Calls (Digital)
When you receive an individual call, a ringing tone will
sound and the caller’s ID will appear on the display (types I
and II only). To respond to the call, press and hold the PTT
switch and speak into the transceiver as you would during a
normal transmission.