Unscrewing the doors, Connecting the appliance to the water supply – Siemens KA58NA45 User Manual

Page 40

Advertising
background image

40

Unscrewing the doors

If the appliance will not fit through the
house door, the appliance doors can
be unscrewed.

We recommend that installation is
carried out by our customer service.

Unscrewing the freezer
compartment door

S Remove lower cover.

S Loosen the hose connection:

Loosen the hose clips on the hose
connection.

Press the clamping ring in the direcĆ
tion of the arrow and simultaneously
pull the hose out of the hose
connection.

S Remove the upper hinge cover (1).

S Disconnect the electrical

plugĆandĆsocket connections (2).

SW 10

S While holding the door, unscrew the

hinge screws on top (3).

S Lift the door off the lower hinge pin.

Remove and deposit the door
with care! Do not damage the
water line.

Unscrewing the refrigerator
compartment door

S Unscrew the refrigerator comĆ

partment door in the same way
(the refrigerator compartment door
does not feature any electrical
plugĆandĆsocket connections or
hose connections).

Warning:
Before installing the doors in reverse
sequence, ensure that the appliance
is level in the installation location.

Connecting the appliance
to the water supply

The water may be connected only by a
competent fitter according to the local
regulations of the appropriate water
supply company.

Connect the appliance to a cold water
line.

- Minimum pressure: 0.1 Mpa (1,0 bar)

- Maximum pressure up to 1.0 Mpa

(10.0 bar)

Depending on the local conditions, it
may be necessary to install a pressure
reducer in the water line.

The tap ¾" for connection of the enĆ
closed line should be freely accessible.
The enclosed connection lines are
1.5 m and 7 m long.

Taste and odour of the water may be
improved by installing the enclosed
water filter. If this is the case, observe
the different connection requirements ć
see Water filter.

Connection

S Connect the line to the solenoid

valve.

S Connect the line to the tap.

S Using the enclosed clips, attach the

connecting line to the rear panel of
the appliance and to the room wall.

S Place the connecting line in loops or

coils so that the appliance can be
moved away from the wall.

en

Advertising