Kenwood KRF-V8300D - Manual (Page 33)

English
33
Set
u
p
5
Continue the measurement.
7 If a confirmation message (fi) is displayed:
Use [MULTI CONTROL
3] to select "Continue".
[ENTER]
7
If an error message ( ›) is displayed:
Use [MULTI CONTROL 3] to select "Retry".
[ENTER]
The measurement starts again.
6
Auto Setup completes.
The display changes from "Analyzing" to "Complete" when
Auto Setup completes.
When "Confirm" is displayed, pressing the [ENTER] key
makes it possible to confirm the measurement data. (See
<To confirm the measurement data>
‹.)
Use [MULTI CONTROL 2/3] to select "Return".
[ENTER]
• Certain listening room properties may cause errors in the results
of measurements of the speaker levels and distances. In this case,
set up the unit again using "Manual Setup". (See <Speaker setup
–"Manual Setup"–>
fl.)
• If the speakers or speaker placement have changed after auto
setup, perform the auto setup again.
To confirm the measurement data
1
Select "Confirm" and press [ENTER] in step 3.
2
Use [MULTI CONTROL 2/3] to select the item to be
confirmed and press [ENTER]. And then use [MULTI
CONTROL
2/3] to confirm its data.
The following setting data can be confirmed.
– Speaker configuration ("SP Setup")
– Speaker levels ("SP Level")
– Speaker distances ("SP Distance")
– Crossover frequency ("Crossover")
For details on the setting items, see <Speaker setup
–"Manual Setup"–>
fl.
To cancel measurement in the middle
Any of the following operations will stop the measurement in the
middle and returns the display to the normal input display.
• Power ON/OFF
• Pressing the [AUTO ROOM EQ] key
• Press the [SETUP] key
• Pressing the [INPUT SELECTOR] key
B60-5740-00_00_EN.indd 33 B60-5740-00_00_EN.indd 33 08.7.17 3:29:56 PM 08.7.17 3:29:56 PM