Kenwood KMR-700U - Manual (Page 25)

English | 25
Installation
Main unit Installation
1 Attach the template (accessory 5) at the
installation position.
2 Tap holes (main unit mounting hole x 1, screw
holes x 7) on the mounting surface based on the
template (accessory 5).
Mounting surface
8.5
4.0
77.5 77.5
36.0 36.0
79.0 79.0
91.0 91.0
66.0 52.0
(mm)
⁄
• Decide the size of screw holes according to the mounting
surface material.
3 Remove the template (accessory 5).
4 Install the main unit.
Tapping screw
(Φ4 x 30 mm)
(Accessory3)
Waterproof rubber
⁄
• Install the main unit together with the waterproof rubber.
Waterproof feature is only provided with the waterproof
rubber attached.
Hideaway unit Installation
Tapping screw (Φ4 x 16 mm)
(Accessory4)
⁄
• Install the hideaway unit in a place free from water
exposure.
• Before installation, check that no fuel tank, pipe, nor wire
exists at backside of the mounting surface, to prevent
screws from penetrating into such component.
B64-4406-00_00_KMR-700U_K_en.indd 25 B64-4406-00_00_KMR-700U_K_en.indd 25 09.2.16 11:00:12 AM 09.2.16 11:00:12 AM