Kenwood KMR-700U - Manual (Page 27)

English | 27
The messages shown below display your
systems condition.
Protect (Blink):
The speaker wire has a short-circuit or
touches the chassis of the vehicle, and then
the protection function is activated.
➪ Wire or insulate the speaker cable properly
and press the reset button. If the “Protect”
code does not disappear, consult your
nearest service center.
Unsupported File:
An Audio file is played with a format that this
unit can’t support.
Copy protection:
A copy-protected file is played.
Read Error: The file system of the connected USB device
is broken.
➪ Copy the files and folders for the USB
device again. If the error message is still
displayed, initialize the USB device or use
other USB devices.
No Device: The USB device is selected as a source
although no USB device is connected.
➪ Change the source to any source other
than USB. Connect an USB device, and
change the source to USB again.
N/A Device: • An unsupported USB device is connected.
• Connection to the iPod has failed.
➪ Check that the connected iPod is an iPod
that is supported. See <About Audio file>
(page 21) for information on supported
iPods.
No Music Data: • The connected USB device contains no
playable audio file.
• Media was played that does not have data
recorded that the unit can play.
USB Error: Some trouble may have occurred to the
connected USB device.
➪ Remove the USB device, then cycle the
power switch to ON. If the same display is
repeated, use another USB device.
iPod Error: • Connection to the iPod has failed.
➪ Remove the iPod and then reconnect it.
➪ Confirm that the software for the iPod is
the latest version.
• Some trouble may have occurred to the
connected iPod.
➪ Remove the iPod, then cycle the power
switch to ON. If the same display is
repeated, use another iPod.
REMO ERROR: Some trouble may have occurred to the
connected Remoto control.
➪ Remove the Remoto control and then
reconnect it.
USB REMOVE (Blink):
The Remove mode has been selected for the
USB device. You can remove the USB device
safely.
iPod REMOVE (Blink):
The Remove mode has been selected for the
iPod. You can remove the iPod safely.
Favorite:No Memory:
The procedure is not registered to Favorite
Preset Memory
No Access: The procedure preset with Favorite Control
cannot be available. The preset content may
not be recalled depending on the selected
source or mode.
B64-4406-00_00_KMR-700U_K_en.indd 27 B64-4406-00_00_KMR-700U_K_en.indd 27 09.2.16 11:00:12 AM 09.2.16 11:00:12 AM