Phottix Mitros for Nikon - Manual (Page 9)

9
En INSTRUCTION MANUAL
To Exit Wireless Triggering Mode
1. Press and hold the button for 2 seconds until “Master” or “Slave” is
highlighted in the upper left corner of the screen;
2. Press the or buttons to cycle between Master, Slave, OS and
Wireless Off modes;
3. Select the Wireless Fn OFF (wireless off) and press the button to con-
firm.
Using Wireless Triggering
With a flash in Master mode on the camera and remote flashes in Slave mode,
pressing the shutter button will fire the Master flash (if set to Master with flash)
and set off any flashes set to Slave mode within the range. The camera and flash
will meter the scene and fire flashes in TTL mode to properly expose the scene.
Master Mode: What can be set on the Master flash?
Master Flash Mode: TTL, Manual, Multi, Master without flash, EV adjustments,
Manual (M) mode power level.
Slave Flash Mode: TTL, Manual, Group Off, EV adjustments, Manual (M) mode
power level
Channel: Transmission channel
Zoom: Flash Head Zoom on Master flash
Multi Mode Settings: Multi power levels, frequency, flash count
Slave Mode: What can be set on Slave flashes?
Group: A, B or C
Channel: Reception channel
Zoom: Flash Head Zoom on Slave flash
Please note:
If Multi mode is set on the Master flash, all slave flashes will operate in Multi
Mode. Groups can be turned off from the Master. All flashes must use the
same flash power, frequency, flash counts.
The adjustable parameters under wireless flash mode are as follows:
Please note:
1. When in the Wireless Mode interface, press button to enter the setup
screen, then press the or buttons to cycle between options.
2. Press the or buttons to cycle between parameters;
3. Multi Mode cannot be used with TTL or Manual modes;