Videotec ULISSE - Manual (Page 14)

EN - English - I
nstruc
tions manual
12
6.4 Preparatory work before
installation
6.4.1 Attaching the support
Use the wall UPTWBA or parapet UPTWBTA support.
Choose the most suitable one for your installation
and follow all the instructions given in this section.
h The device should be assembled vertically.
Any other position could impair the
performance of the appliance. Do not
attach the device upside down.
h Take special care when attaching and
fastening down the apparatus. If it is to be
attached to a concrete surface you must
use dowel pins with a traction torque rating
of at least 300dN each; for a metal surface
use screws with a diameter of at least 8 mm
and of an appropriate length. However, the
clamping system must be able to support
at least 4 times the weight of the entire
equipment, including P&T, lenses and
camera.
6.4.1.1 Attachment with bracket (optional)
The bracket is drilled to make it easy the connection
cables through it. The base can be attached to the
wall bracket in 4 distinct positions, turning through
90° to each other, in order to facilitate positioning of
the configuration board.
110
Ø 9
150
Fig. 08
6.2 Contents and unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• ULISSE positioning unit
• Accessories box:
• Allen key
• Sachet desiccant
• Attachment plate with screws
• Bolts and screws
• Serial extension cable
• Serial adapter
• Label
• Silicon sheath
• Ties
• Reduction gaskets for cable glands
• Instructions manual
• Power Supply Base Box:
• Power supply base
• ULISSE IR Accessories Box:
• Infrared illuminators bracket
• Bolts and screws kit for fastening the bracket
and the infrared illuminators
6.3 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.