Videotec ULISSE - Manual (Page 53)

EN - English - I
nstruc
tions manual
51
11 Instructions for normal
operation
11.1 Visualizing the state of the
pan & tilt
During normal operation the pan & tilt displays
on screen the data organized as illustrated (user’s
choice). Visualization can be enabled or disabled as
described in "9.6.8 Display menu", page 42.
ID 1: Receiver’s address;
ZONE 1: Name of the area where one is currently
located;
MASK 1: Name of the mask where one is currently
located
ALARM 1: Text regarding the last active alarm;
Preset 001 go to: Commands received via serial;
E1 PATROL CONFIGURATION: The following field
shows the errors found while the system was running;
PAN/TILT/Z/F/I: Current position of PAN, TILT, ZOOM,
FOCUS and IRIS;
PRESET 001: Name of selected active preset.
ID 1
ZONE 1
MASK 1
ALARM1
Preset 001 go to
E1:PATROL CONFIGURATION
PAN : +000.00
TILT: +000.00
Z:000.0 F:000.0 I:000.0
PRESET 001
Fig. 124
10.1.1 Connecting the pump
h The connections illustrated below should
be made only and exclusively by skilled
operatives who should comply scrupulously
with all the wiring and power supply
instructions. Failure to do so could create
serious risks for the operator and would
invalidate the guarantee.
Signal
O1 C1
AL1
COM
Fig. 123 Signal connector on the base board of the pan & tilt.
All models in the ULISSE series have this function.
The diagram shows:
• AL1 - COM: Alarm input, to monitor the presence
of water in the tank. For devices with level sensors,
closure of the contact, if enabled, generates an
appropriately configured on screen alarm.
• O1 - C1: Clean contact for starting the water pump.
10.1.1.1 Connection with a washer system
in the UPTWAS/WASPT series
For the connections see the product installation
handbook. Some models may not have a washer
liquid level sensor.