Videotec ULISSE - Manual (Page 16)

EN - English - I
nstruc
tions manual
14
7.1.2 Connection of the camera and
motorised lens
7.1.2.1 Motorised lens PTZ board
The following is a description of the electronics board
inside the housing, which controls all functions of the
motorised lens.
CODE DESCRIPTION
CN1 BNC connector for connecting the video signal
from the camera
CN2 Motorised lens motor control connector
CN3 Motorised lens potentiometer connector
CN6 Serial connector for controlling the camera
CN7 Camera power supply, clean contact for
activating the camera night mode, additional
lines
Tab. 01
CN7
CN2
CN1
CN6
CN3
Fig. 14
7.1.1.2 Camera installation
Take out the inner support slide (01) loosening the
fastening screws (02). Attach the camera using the
1/4" screw and adjust the internal slide so that the
lens and camera are positioned correctly.
Fasten down the adjustable slide in the correct
position using the appropriate screws. When
positioning the camera use also the spacers supplied
for this purpose (03).
03
02
01
Fig. 12
Reposition the inner slide and tighten the screws that
had been loosened previously. Attach the essicant
bag using the bracket for this purpose.
Fig. 13
Close the housing after making the necessary
electrical connections.
h It is necessary to insulate the camera body
from the attachment slide in order to
prevent interference with the video signal.