MagTek Excella STX99875342 - Manual (Page 16)

Excella STX Installation and Operation
8
PRINTER/CARTRIDGE INSTALLATION AND REMOVAL
Printer/Cartridge Installation
To install the Printer/Cartridge, refer to Figure 2-4 and perform the following:
1. Ensure the printer latch is down and locate the guide pins on the Printer/Cartridge and the
guide holes in the Printer Base (Inset).
2. Slide the guide pegs into the guide holes as indicted in Figure 2-4.
3. Raise the latch so that it touches the Printer/Cartridge.
4. Press the latch into the lock position, and move the Cartridge slightly to ensure it is locked.
5. Perform steps 1 through 4 on the other Printer/Cartridge located inside of the exit path.
To remove the Cartridge, pull the latch down, and slide the Cartridge out.
Caution
Ensure both latches are up before installing either or both covers,
no matter if the Printer/Cartridges are installed or not.