MagTek Excella STX99875342 - Manual (Page 17)

Section 2. Installation
9
Figure 2-4. Printer/Cartridge Installation and Removal
Center Cover Replacement
To replace the Center Cover, refer to Figures 2-2 and 2-3.
1. Tilt the front of the Cover up, and use the two guide pins, Figure 2-3 , near the rear of the
unit to orient the Cover.
2. Place the guide holes over the pins and slowly lower the front of the Cover so the pins slide
into the holes in the Cover and the front of the Cover latches.
Outer Cover Replacement
1. Place two index fingers on the Release Buttons and two thumbs on the inner race of the
Outer Cover as shown in Figure 2-1.
2. As indicated in Figure 2-1, press the two Release Buttons in, and at the same time slightly
pull the two inner race segments out.
3. Ensure the four brackets at the base remain inside the Outer Cover, and slowly lower the
Outer Cover until it clicks into the locked position.