MagTek IntelliCAT99875658 User Manual
Page 11
<IntelliCAT>| <Migration to Windows 7> | <User Support Document>
Page 11
Step 14
- Local/Network Setup
If the desktp INTCAT.INI file also includes some Mapped Drives or UNC paths, this means
that the old IntelliCAT Setup is a partial local/network setup
Review the Networked Location of the IntelliCAT install by following the mapped drive or UNC path.
14 A
- Locate the old MTAdmin.MDB that is in use
Example of current 1.X setup = \\server1\Magtek\IntelliCAT\MTAdmin.mdb..........
The file will continue to be used during the migration -
DO NOT TOUCH
this file.
14 B
- Locate the old \Operators\MTAdmin.MDB - if present -
Example of current 1.X
setup using an Operator folder =
\\server1\MagTek\IntelliCAT\Operators\MtAdmin.mdb
..........
The file will continue to be used during the migration -
DO NOT TOUCH
this file
Important Note:
DO NOT TOUCH THE FILES
referenced above
Note: The above examples may also point to a mapped drive. The same actions will apply for Step 14
regardless of whether a UNC or mapped drive is being used.
Note: The old 1.XX networked Database(s) will continue to work as the migration takes place, one branch
at a time, AND they will also be used to import the old operators into the new installation with no need to
recreate all of the operator cards currently in use.
Step 15
- Create new folder(s) - Critical Step Must Be Performed for a Network
Installation
Create a new network folder named 2.X_IntelliCAT
On the Network
Create one new folder named 2.X_IntelliCAT if only
14
A
is present above and then,
If an Operators folder is present create a second folder named 2.X_Operators if
14
B
is
present.
o
If
14
B
is not present, do not create the second folder.
15 A. Example 1 = new 2.X setup = \\server1\Magtek\2.X_IntelliCAT\.......
15 B. Example 2 = new 2.X setup = \\server1\Magtek\IntelliCAT\2.X_Operators\......
Note: The same instructions apply if the drive is mapped.
Step 16 - Copying the new 2.XX MtAdmin.MDB and IntelliCAT.MDW to new folder(s)
O.S Dependent
If
15
A IS TRUE
in a 32 bit/64 PC -
NAVIGATE
to C:\...\MagTek\IntelliCAT\
o
LOCATE THE
MtAdmin.MDB and IntelliCAT.MDW on the new PC,
o
COPY
and
PASTE
both new files to the new 2.X_IntelliCAT NETWORK folder,
i.e.
\\server1\Magtek\2.X_IntelliCAT\
If
15
B IS TRUE
in a 32bit/64bit PC, an Operator(s) folder is present, navigate to
C:\....\MagTek\IntelliCAT\
o
LOCATE
MtAdmin.MDB on the new PC and
o
COPY
and
PASTE
the new MtAdmin.MDB to the new 2.X_Operators NETWORK
folder.
i.e.
\\server1\Magtek\IntelliCAT\2.X_Operators\