MagTek P-SERIES USB - Manual (Page 42)

P-Series USB Insertion Reader
34
Property ID is a one-byte field that contains a value that identifies the property. The following
table lists all the current property ID values:
Value Property ID Description
0 SOFTWARE_ID The device’s software identifier
1 SERIAL_NUM The device’s serial number
2 POLLING_INTERVAL The interrupt pipe’s polling interval
27 TRACK_ID_ENABLE Track enable / ID enable
26 TRACK_DATA_SEND_FLAGS Track data send flags
5 TERMINATION_CHAR Terminating char / per track or card flag
6 SS_TK2_7BITS Start sentinel char for track 2 – 7 bit data
7 Reserved for future use
8 SS_TK3_ISO_ABA Start sentinel char for track 3 – ISO/ABA
9 SS_TK3_AAMVA Start sentinel char for track 3 - AAMVA
10 SS_TK3_7BITS Start sentinel char for track 3 – 7 bit data
11 PRE_CARD_CHAR Pre card char
12 POST_CARD_CHAR Post card char
13 PRE_TK_CHAR Pre track char
14 POST_TK_CHAR Post track char
15 ASCII_TO_KEYPRESS_CONV
ERSION_TYPE Type of conversion performed when
converting ASCII data to key strokes
16 INTERFACE_TYPE Type of USB interface
17 ACTIVE_KEYMAP Selects which key map to use
18 PRE_CARD_STRING Pre card string
19 POST_CARD_STRING Post card string
20 SS_TK1_ISO_ABA Start sentinel char for track 1 – ISO/ABA
21 SS_TK2_ISO_ABA Start sentinel char for track 2 – ISO/ABA
22 ES End sentinel char for all tracks/formats
3 MSR_DIRECTION Magnetic stripe read direction
4 CARD_INSERTED Card inserted indicator
28 SENSOR_BLOCKED_CHAR Sensor blocked char
29 SENSOR_UNBLOCKED_CHAR Sensor unblocked char
23 ES_TK1 End sentinel char for track 1
24 ES_TK2 End sentinel char for track 2
25 ES_TK3 End sentinel char for track 3
The Property Value is a multiple-byte field that contains the value of the property. The number
of bytes in this field depends on the type of property and the length of the property. The
following table lists all of the property types and describes them.
Property Type Description
Byte
This is a one-byte value. The valid values depend on the property.
String This is a multiple byte ASCII string. Its length can be zero to a
maximum length that depends on the property. The value and
length of the string does not include a terminating NUL character.