MagTek MINIWEDGE SWIPE READER - Manual (Page 11)

5
SECTION 2. INSTALLATION
The MiniWedge Reader cable is a Y cable that permits the MiniWedge Reader to be installed
between the PC and the PC keyboard. There is also an adapter cable that is used to adapt various
connector configurations to interface with the Reader. These configurations are described and
illustrated below.
HARDWARE INSTALLATION
To install the MiniWedge Reader proceed as follow:
Mounting
1.
The Reader can be mounted on a surface in three ways:
•
By two screws through the surface attached to the bottom of the unit and running the
cable on the top of the surface;
•
By two screws through the surface attached to the bottom of the unit and by drilling a
hole in the surface for the cable and running the cable through the hole;
•
By attaching the unit to the surface with Velcro or Dual Lock mounting pads and
running the cable on the top of the surface.
Note
The two mounting inserts are 3 mm diameter; 0.5 mm pitch; 6.4
mm deep. The length of the screws used depends on the mounting
surface thickness and the thickness of washers (if used).
The mounting dimensions are shown in Figure 2-1. Determine the method of mounting
required.
2. Ensure the Reader is positioned on a flat, accessible surface with at least 4 inches
clearance on either end for room to swipe a card. Orient the Reader so the side with the
LED is facing the direction of intended use.
If Velcro or Dual Lock mounting pads are to be used, clean the area that the Reader will
be mounted on with isopropyl alcohol. Remove the adhesive protective cover on the
pads, and position the Reader and push down firmly.
3. Mount the Reader.