Waterloo F1880 - Manual (Page 3)

Ball bearing slide - Pull slides and slide carrier out to fully
extended position (see illustration.) Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and reclose to ensure proper operation.
INSTALLING DRAWERS
Friction Style - Fully extend the drawer. Insert screwdriver
into the slot in the side and push in on the stop until it
clears the lance. Pull drawer just past lance before
releasing stop. Repeat the process for the other slide.
Tab Style - Depress the release tabs on both sides,
(this allows the slides to ride over the stops).
Pull out to remove.
Lever Style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops). Pull out to remove.
REMOVING AND INSTALLING SLIDES
Rivet Style -
• To remove the slide from the unit, first remove the
drawer.
• After removing the drawers drill out the rivets, use a
5/32-in drill bit. The rivets will need to be replaced.
• To reinstall the slide, place the slide in the appropriate
position in the unit and pull toward the front of the unit.
Replace rivets to secure slide to the unit.
• For smooth operation, make sure the drawers are
matched with their original slides.
Snap-In Style -
• First remove the drawer. (See section B.)
To remove the slide:
• Push slide to the closed position.
• Insert flat tip screwdriver between slide and unit, behind
rear rectangular cutout.(See illustration.)
• Rotate screwdriver ¼ turn to force slide away from unit.
• Push on front of slide pushing it towards back of the unit.
To attach the slide:
• Extend slide and locate lances within respective cutout
in carrier.
• Pull slide forward until slide locks back into place.
• Reinstall drawer following drawer installation procedure.
(See section C.)
5
4
OPERATION OPERATION
slide carrier
slide
Drill out rivet