Wagner Power_Roller_Max - Manual (Page 4)

English 4
Setup
Setup:
Roller assembly setup:
1. Before using the unit, make sure the inlet plug is
screwed tightly into the Quick-clean™ adapter, or
material will leak from the adapter opening.
1. Assemble core (g), roller cover (h), and cap (i).
3. Attach spatter shield.
3. Place paint can on the base and insert the lid tab onto
the opening on the tower. Press the tab over the tower
post (c).
2. Tightly place the lid on the paint can. Align arrow (a)
and paint can handle (b) as shown.
2. Attach assembly to arm, making sure the roller
assembly snaps into the locking tab (j) as shown.
4. Press the quick-release tabs (k) on the handle and
attach the arm to handle. When using the extension,
attach the arm to the extension, then attach the
extension to the handle.
4. Insert the suction tube until it reaches the bottom of the
can.
(c)
(i)
(h)
(g)
(j)
(k)
(a)
(b)