Airlink101 APO1010 - Manual (Page 137)

132
6.3.2 MAC Filter Setup
The administrator can allow or reject clients to access repeater AP.
Please click Wireless -> MAC Filter and follow the below settings.
„ MAC Filter Setup : By default, it’s “Disable”. Options are Disabled, Only Deny List MAC or Only Allow List MAC.
Click Save button to save your change.
Two ways to set the MAC filter rules :
Î Only Allow List MAC.
The wireless clients in the MAC Filter List will be allowed to access to Access Point; All others will be denied.
Î Only Deny List MAC.
The wireless clients in the MAC FIlter List will be denied to access to Access Point; All others will be allowed.
„ MAC Address : Enter MAC address (e.g. aa:bb:cc:00:00:0a) and click “Add” button, then the MAC address should
display in the MAC Filter List.
There are a maximum of 20 clients allowed in this MAC Filter List. The MAC addresses of the wireless clients can be added
and removed to the list using the Add and Delete buttons.
Click Reboot button to activate your changes
MAC Access Control is the weakest security approach. WPA or WPA2 security method is highly recommended.