Airlink101 APO1010 - Manual (Page 18)

13
2.1.2 Panel Function Descriptions
¾ APO1000
Front Panel Rear Panel
1. Reset Button : System reboot button press until LED flashed and release for system reboot or for reset
to factory default press, LED flashes keep pressing until LED becomes static
2. Power : Red LED ON indicates power on, and OFF indicates power off
3. Signal Strength : Yellow LED ON indicates Low Signal (CPE Mode)
4. Signal Strength : Green LED ON indicates Normal Signal (CPE Mode) or (WDS Mode only)
5. Signal Strength : Green LED ON indicates High Signal (CPE Mode) or (AP Mode only)
6. WLAN : Green LED BLINKING indicates Wireless ON, and BLINKING quickly indicates Wireless
Transmit quickly.
7. Ethernet : Green LED ON indicates connection, OFF indicates no connection
8. PoE Connector : For connecting to PSE
9. N-Type Connector : For connecting to N-Type antenna
In CPE Mode, the LED 3 ON indicates the signal Low ( Signal <= 10 RSSI); the LED 3 and 4 ON indicate the
signal Normal (10 < Signal <=40 RSSI); the LED 3, 4 and 5 ON indicate the signal High ( Signal > 40 ).
Only LED 4 ON indicates the operating mode is WDS Mode; only LED 5 ON indicates the operating mode is
AP Mode.